Customized Duplex Uniboot Fiber Patch Cable, LC UPC, OS2
For Pakistani procurement and engineering teams, the specification provides a practical basis for checking compatibility before production is requested. This custom-built fiber patch cable is built to the precise setup the project specifies: connector styles, polish, fiber mode, jacket and length are all specified at order time and the terminated assembly is factory terminated and optically tested before dispatch.
Product Highlights
- Offered in Riser (OFNR)/LSZH Flame-retardant Jacket with 1.6/2.0mm Cable Diameters
- Available in Standard/Flat Clip and Push Pull Tabs Connector Types
- Uniboot Design Allows One Cable to Carry Two Fibers to Reduce the Cable Bulk When Routing
- Optical Performance Test for Normal Network Connections
- Compliant to ANSI/TIA-568-D.3
Specifications
| Fiber Mode | OS2 9/125μm |
|---|---|
| Wavelength | 1310/1550nm |
| Fiber Count | Duplex |
| Fiber Grade | G.657.A1 |
| Insertion Loss | UPC≤0.2dB |
| Return Loss | UPC≥50dB |
| Attenuation at 1310 nm | ≤0.4dB/km |
| Attenuation at 1550 nm | ≤0.3dB/km |
| Cable Outside Diameter (OD) | 1.6/2.0mm |
| Jacket Color | Yellow |
| Polarity | A (Tx) to B (Rx) |
| Operating Temperature | -10 to 60°C (14 to 140°F) |
Built to the order
The custom-built program covers the combinations that stock lists cannot: mixed connector families, non-standard jackets, unusual lengths, identification and packing to the project specification. The terminated assembly is terminated and tested exactly like a stock product, with the setup confirmed before factory assembly.
Bend tolerance in real cabinets
Patch fields are rarely kind to fiber. Patch cords path through tight managers, sharp tray corners and crowded vertical channels. The bend-insensitive glass in the product assembly tolerates a 10mm fiber bend radius, and therefore a hurried routing decision during a night servicing window does not by itself turn into a measurable penalty on the connection.
Where single-mode jumpers earn their place
Single-mode patching carries the links that leave the room: campus backbones, carrier handoffs, long runs between buildings and each wavelength-multiplexed service. Because the OS2 glass in the product assembly is the identical group used in the outside plant, the optical jumper does not by itself become the weak point of the optical loss calculation. At 1310 and 1550nm the attenuation stays a fraction of a decibel per kilometer, and the optical interface pair adds less than 0.3dB when the end faces are clean and seated.
Length Options
Catalogue lengths cover the common patching routes: 1m (3ft), 2m (7ft), 3m (10ft), 5m (16ft), 10m (33ft), 15m (49ft), 20m (66ft), 30m (98ft), with custom-built length offered beyond the list. Specifying the measured path length keeps the slack out of the manager and the strain off the optical interfaces.
Quality Control and Testing
Every manufactured assembly is terminated with precision zirconia ferrule connectors and optically tested before packing: insertion loss and return loss are verified on every cable, and end-face geometry is inspected for consistent physical contact. The installed cable ships with dust caps on the two connectors and the test result offered on specify.
Ordering and Factory Support
Refer to this setup by connector pair, fiber mode and length when specifying a quotation. For configurations outside the listed options, mixed connector families, jackets, identification or project packing, send the specification with the request and the factory will make certain of the build before factory assembly. For Pakistan, a clear port or maintenance schedule helps us confirm the correct factory-built configuration before supply.
